RV & Trailer Appliance Repair | Twin Falls & Kimberly, ID
Appliances make trips comfortable… until they don’t. Total Trailer services RV and trailer appliances for customers in Twin Falls, Kimberly, and across the Magic Valley. We diagnose and repair fridges, furnaces, roof A/C units, water heaters, stoves/ovens, and thermostats.
Expect clear quotes, photo documentation, and practical guidance when replacement is smarter than repair. Mobile service is available for many issues, shop service is used when lifts, pressure tests, or bench work are required.
What We Service
Refrigerators: 12V compressor & LP/electric absorption (Dometic, Norcold, etc.)
Furnaces: ignition, fans, boards, thermostats (Suburban, Atwood)
Roof A/C: fans, capacitors, control boards, thermostats (Airxcel, Furrion, etc.)
Water Heaters: LP/electric elements, anodes, control boards (Suburban, Atwood)
Cooking Appliances: stoves/ovens, regulators, igniters
Thermostats & Controls and basic LP supply checks (leak-safe procedures)
NOTE: We DO NOT work on Aqua-Hot systems
Common Problems
Fridge cools on shore power but not on LP / throws codes
Furnace cycles without ignition or blows cold air
Roof AC fan runs but no cold, or trips breaker
Water heater won’t fire, lukewarm water only, or leaks at fittings
Oven won’t light, weak or uneven flame
Mobile or In‑Shop
Mobile (on-site): most thermostat faults, board swaps, igniters, fans/caps, elements, common leak/connection fixes.
In-Shop: complex wiring, sealed cabinet work, bench testing, appliance swaps requiring cabinetry, and diagnostic scenarios needing stable power and tooling.
FAQ
Can you fix a fridge that cools on electric but not on propane?
Usually. Typically the problem is ignition, thermocouple, board, or venting. We test both modes.
Do you recharge roof A/C units?
No. RV roof A/Cs are sealed. If the sealed system fails, replacement is the reliable fix. We do repair fans, capacitors, and boards.
Will you come to my RV park or site?
Yes. If bench work is required, we’ll coordinate shop service.
Can you replace an absorption fridge with a 12V compressor model?
Yes, case-by-case. We’ll review power draw, wiring, venting, and cabinet fit.
What info should I provide before the appointment?
Appliance brand/model/serial, error codes, clear photos of the unit and data tag, and your power/LP setup (shore power, generator, battery).